Alarming

• Voltage & Amperage Imbalance Triggers

  Two separate Alarm Triggers measure imbalances on the meter and generate alarms: Voltage Imbalance, Amperage Imbalance.  When new interval data comes in for the meter, LightLevel checks the 3 phases a...

• Inverter Triggers

  Fault State Trigger When new interval data comes in LightLevel will check the fault registers of an inverter and if any fault registers are active, will generate an alarm. Bad Inverter Data Every day,...

• Bad Sensor Data Trigger

  Every day, LightLevel will check sensor data from the previous day. If the sensor is not reporting any useful data, an alarm will be generated...

• Production Irradiance Variance Trigger

  Every 4 hours, LightLevel will analyze the past 4 hours of meter and sensor data. LightLevel will calculate the site's expected production for that 4 hours and compare that with the actual production ...

• Lost Communication & No Production Triggers

  Lost Communication At every 15-minute interval, LightLevel makes a ping request to each meter in the system, to see if it can establish a connection. After a successful ping, LightLevel will request t...

• Manage Triggers

  In each Main page's Configuration tab, organization admins can activate/deactivate alarm triggers. The table will list all possible device/alarm trigger combinations. If a trigger is active for a give...